THE STICK ON

BLACK PLASTIC MICROPHONE "STICK ON" HOLDER FOR CB RADIO'S

THE SALE IS FOR 1 UNIT WITH OTHER AVAILABLE THE PICTURE SHOWS FULL CONTENT

1 ADHESIVE MIC CLIP 

SAVE TIME AND EFFORT FROM DRILLING (SEE INSTRUCTIONS these are now on the rear of the invoice) YOUR VEHICLE AND USE THE STICK ON MIC TO HOLD YOUR MICROPHONE

THE STICK ON WILL STICK TO ANY CLEAN FLAT SOLID SURFACE VIRTUALLY ANYWHERE IN YOUR VEHICLE

DASH BOARD - MIRROR - SIDE CONSOLE - WIND SCREEN - NOT FOAM BACKED

THE STICK ON IS MADE FROM BLACK PLASTIC THE OVERALL LENGTH IS JUST OVER 4 cm AND 3 cm WIDE AND 1.3CM IN DEPTH

THE STICK ON SLOT IS 1 cm WIDE AND 2 cm LONG

IT CAN BE USED FOR CB MIC'S OR TAXI RADIO MIC'S IT MAKES NO DIFFERENCE TO THE STICK ON MIC HOLDER
THE STICK ON COMES WITH 1 ADHESIVE PAD (ORIGINAL) THAT IS ON THE REAR OF THE HOLDER THEN ANYWHERE IN THE CAB DON'T WORRY IF YOU NEED MORE PATCHES, WE SELL SIMILAR ITEMS IN OUR STORE (UNDER MIRROR PADS FOR CAMERA'S)

TREAT YOUR MICROPHONE TODAY - DON'T DELAY - BUY ONE TODAY

STANDARD SCREW ON MIC HOLDERS IN A CHROME FINISH & HOOK MIC'S ARE ALSO AVAILABLE AS USUAL

TECHNICAL NOTES:

WITH ALL ADHESIVE PRODUCTS, TEMPERATURE IS CRITICAL TO THE GLUE, THEY JUST DON'T LIKE THE COLD OR COLD SURFACES, SOME PREPARATION IS REQUIRED BEFORE USE, THE SURFACE THAT YOU WISH TO APPLY IT TO MUST BE CLEAN AND FREE FROM LOOSE PARTICLES. WE USE " METHYLATED SPIRITS" TO CLEAN ANY POLISH, GREASE OR DIRT AWAY. THE ADHESIVE WILL STICK EASILY TO THIS, THE AMBIENT TEMPERATURE SHOULD BE AT LEAST ABOVE 15 DEGREE'S CELSIUS . ONCE STUCK LEAVE FOR 24 HRS FOR THE GLUE TO CURE IN A WARM ENVIRONMENT , THEY DON'T LIKE BEING MOVED OR FINGER PRINTS OVER THEM. MAKE SURE THE SURFACE YOU ARE ADHERING TO IS FLAT AND SOLID PLASTIC/METAL - NOT FOAM BACKED (THIS MOVES) ONCE STUCK SHOULD LAST FOR AGES WEIGHT PERMITTING.